We find the leak before selling the fix
Every repair starts with locating the actual loss. Sealing the joints you can reach while the real problem sits behind a truss is not a repair.
Free written estimates · On call 24/7
A disconnected branch in a 140-degree attic is not a small leak — it is a room that never gets comfortable.
Licensed & insured · 127 five-star reviews
Fast response. No obligation.
Duct leakage is the most expensive problem in a Sacramento home that nobody can see. A branch that has pulled loose at the plenum is dumping cooled air into an attic that is already 140 degrees in July, and the only symptom in the house is one bedroom that never quite gets there. Older homes here often have duct joints held with cloth tape that dried out and released decades ago. Newer tract homes have their own version: flex duct crushed against a truss, kinked around a corner, or hung with too much slack so it sags into an S-shape that throttles the run. None of it shows up on a thermostat. It shows up as a system that runs constantly and a bill that does not match the house.
If you are not satisfied with the result, we come back and make it right at no charge.
Benefits
Every repair starts with locating the actual loss. Sealing the joints you can reach while the real problem sits behind a truss is not a repair.
Joints are sealed with mastic and mesh, which stays flexible and bonded for decades. Cloth duct tape is what caused most of the failures we find.
A branch that has separated at the plenum is reattached and mechanically fastened, not pushed back on and taped.
Sections that are crushed, torn or sagging are replaced and re-hung with proper support so the run holds its shape.
The connections at the plenum and at each register boot are the highest-loss points and they are treated as the priority.
We measure at the affected registers afterwards so you can see the room actually got its airflow back.
Warning signs
Call (916) 260-2551 or request a quote online.
Process
The system is inspected at the plenum, the branch takeoffs and the boots, and the runs are traced through the attic or crawlspace.
Photographs of each fault, so you can see the disconnected branch or the crushed run for yourself before approving the work.
Separated branches are reattached at the takeoff and fastened so the joint is held by more than adhesive.
Joints, plenum connections and boot seams are sealed with mastic, which remains flexible instead of drying out and releasing.
Crushed, torn or badly sagging flex sections are replaced and re-hung with proper support and spacing.
Airflow is measured at the affected registers and compared against the starting readings.
Questions
The usual sign is a room or two that never gets comfortable while the rest of the house is fine, combined with a system that runs far longer than it should. We inspect and photograph before recommending anything.
Usually, and it is far cheaper. If the duct itself is intact and the losses are at the joints and boots, sealing is the right call. We only recommend replacement when the duct is genuinely failed.
Recovering air that was being dumped into the attic generally shows up on the bill. We will not put a percentage on it in advance, because the answer depends entirely on how bad the starting leakage is.
Yes. Crawlspace runs are common in the older Land Park, Curtis Park and Carmichael housing stock and they are frequently the worst offenders because of moisture and rodent damage.
More
Whole-system cleaning under truck-mounted negative pressure, with camera photos of every trunk line before and after.
Learn more about Air Duct CleaningFull-length vent brushing from the drum connection to the exterior hood, with an airflow test before we leave.
Learn more about Dryer Vent CleaningBlower wheel, housing and evaporator coil cleaned properly, with the condensate drain flushed while access is open.
Learn more about HVAC Coil & Blower CleaningAir Conn
1304 Lynette Wy
Sacramento, CA 95831
(916) 260-2551
info@airconnsacramento.com
| Monday | 12:00 AM - 11:59 PM |
|---|---|
| Tuesday | 12:00 AM - 11:59 PM |
| Wednesday | 12:00 AM - 11:59 PM |
| Thursday | 12:00 AM - 11:59 PM |
| Friday | 12:00 AM - 11:59 PM |
| Saturday | 12:00 AM - 11:59 PM |
| Sunday | 12:00 AM - 11:59 PM |
Fast response. No obligation.